RECEIVING HOPPER SH-80

  • Productivity up to 7 t/h
  • Capacity 3.5m³/1200 kg
  • Dimensions:
    * length: 350 cm (without separator), 400 cm (with fixed separator)
    or 425 cm (with sliding separator)
    * width: 225 cm
    * height: 180 cm
  • Weight 850 kg
  • Installed power 3 kW / 6 A
  • Power supply 3x400 V+N+PE, plug 5x16A
  • RECEIVING HOPPER <nobr>SH-80</nobr>
  • RECEIVING HOPPER <nobr>SH-80</nobr>
  • RECEIVING HOPPER <nobr>SH-80</nobr>
  • RECEIVING HOPPER <nobr>SH-80</nobr>
  • RECEIVING HOPPER <nobr>SH-80</nobr>
  • RECEIVING HOPPER <nobr>SH-80</nobr>
  • RECEIVING HOPPER <nobr>SH-80</nobr>

RECEIVING HOPPER SH-80

The hopper is used to receive goods from crates rotated by a turntable mounted on a forklift, or in a square version to receive vegetables from a WHM 700 or WHM 1500 tipper. The hopper is equipped with a strong chevron-type belt with a width of 80 cm and a height of the takers of 16 mm. As an option, it is possible to purchase an inverter for adjusting the belt of the hopper, as well as a 6-roller soil separator driven by an independent motor (which can also be equipped with an inverter). The soil separator in the standard equipment has a fixed spacing, and as an option it can be adjusted in the range of 10-70 mm, in which case each roller has its own motor and the speed can be adjusted in 2 ways: the whole by one inverter, or alternate rollers by 2 inverters. It is possible to mechanically adjust the angle of the separator in the hopper. The height of the hopper can be adjusted by means of extendable legs, in the range from 95 to 125 cm (the height at the exit of the belt from the hopper). The hopper is also available in a square version, adapted to receive products from the WHM tipper, so that it is possible to place the tipper in any direction in relation to the hopper: from one of the sides or straight ahead.

Basic equipment

  • Painted construction RAL 7024 + galvanized sheet metal 
  • Chevron rubber belt with a width of 80 cm and 16 mm takers
  • Wired remote control (4m cable)
  • Constant speed of the main belt approximately 9.5 m/min

Optional equipment

  • Stainless steel construction
  • Speed adjustment of the main belt (1 inverter)
  • Additional 1/3 reduction gearbox
  • Separator for SH 80 --6 rollers
  • 1 inverter for all separator rollers (main belt inverter option required)
  • Extendable roller separator system for SH 80
  • 2 inverters for separator rollers 1,3,5 and 2,4,6
  • Changing separator rollers to PU spiral ones
  • Lining the inside of the tank with rubber or foam
  • Photocell
  • Low square basket (if compatible with WHM-700)
  • High square basket (if compatible with WHM-1500)
  • 20 cm extensions
  • Ultrasonic sensor measuring layer thickness
  • Height increase for basket from 50 to 100 cm
  • Remote control
Back